- Frontpage >
- Tips and Inspiration >
- Garden drainage – how to build a soakaway and drain a wet garden
Garden drainage – how to build a soakaway and drain a wet garden
Heavy rainfall leaves many gardens with water standing on the lawn, in the beds or by the patio. It causes mud, moss and dead plants – and in the worst case damp in the house. Fortunately, you can often solve the problem yourself with a soakaway or good drainage.
In this guide you will learn why water collects, how to test your soil, how to build a soakaway and how to drain a wet lawn. See also our range of drainage sand, gravel and stones.
Why does water collect?
Water usually collects because the soil cannot absorb it fast enough. The most common causes are:
- Clay soil: Clay is dense and lets water through slowly.
- Compacted soil: Soil that has been driven or walked on – for example after building work – loses its pores.
- Low ground: Water runs towards the lowest point of the garden and collects there.
- Roof water: A 100 m² roof sends large amounts of water into the garden during a cloudburst.
Test whether your soil drains
Before you start, it is a good idea to do a simple percolation test:
- Dig a hole of about 30 × 30 cm and 30 cm deep.
- Fill the hole with water and let it drain away.
- Fill the hole again and see how quickly the water disappears.
If the water disappears within a couple of hours, the soil drains well and a soakaway will work fine. If the water is still there after a day, you have dense clay soil. Then the soakaway must be larger, or the water must be led away in another way.
What is a soakaway?
A soakaway is a hole in the ground filled with stones that works as an underground water reservoir. Rainwater is led into the soakaway, where it is held between the stones and slowly seeps into the surrounding soil. You can cover it with soil and sow grass, so the soakaway cannot be seen.
A soakaway makes particular sense if you want to lead roof water away from the house, or if water collects in one particular place in the garden.
How to build a soakaway
- Choose the location: Place the soakaway in the lowest part of the garden – but at a good distance from the house (see the next section).
- Dig the hole: A hole of e.g. 2 × 1 metres and 1 metre deep gives a soakaway of 2 m³.
- Line with geotextile: Lay a geotextile membrane on the bottom and sides, so the soil does not clog the stones.
- Fill with drainage stones: Fill the hole with drainage stones 16-32 mm, which leave large voids for the water. Drainage stones 8-16 mm can also be used.
- Connect the inlet: Lead the water into the top of the soakaway through a pipe.
- Close the soakaway: Fold the membrane over the stones and cover with about 30 cm of soil. Then you can sow grass on top.
Rules and distances
There are rules for where a soakaway may be placed. As a rule of thumb, it should be at least:
- 5 metres from houses with a basement
- 2 metres from houses without a basement
- 2 metres from the boundary
In Denmark, you usually need permission from the local authority to discharge rainwater from the roof into the ground, and connecting downpipes must be done by an authorised drainage contractor. Always check the rules with your local authority before you start.
How to drain a wet lawn
If it is the lawn that is wet and mossy, you can often improve drainage without digging a soakaway:
- Aerate the lawn: Spike the lawn with a fork or a hollow-tine aerator to get air into the soil.
- Top-dress with sand: Spread a thin layer of drainage sand 0-2 mm of 0.5-1 cm and brush it into the holes. Repeat a couple of times a year.
- When laying a new lawn: Mix sand into the top layer of soil before you sow or lay turf.
Read more in our guide How to Create a Beautiful Lawn.
Drainage along paths and pipes
If you need to lead water away along a path, a patio or a wall, you can lay a drainage pipe in a trench. Lay the pipe with a slight fall, and surround it with drainage gravel 0-16 mm or drainage stones, so the water can easily find its way into the pipe. It must end in a soakaway or another approved outlet. Perimeter drains around the house are a bigger job that is best left to a professional.
How much drainage material do you need?
The size of the soakaway depends on how much water it must take and how well the soil drains. A commonly used rule of thumb is about 1 m³ of soakaway per 50 m² of roof in sandy soil – and preferably more in clay soil.
Example: A 100 m² roof needs about 2 m³ of soakaway. With a hole of 2 × 1 × 1 metres, you need about 2 m³ = 2,000 litres of drainage stones.
See more calculation examples in How much gravel, sand and soil do I need?, or use our quantity calculator. We deliver drainage stones and drainage sand in bulk bags directly to your address – read more about delivery.